Now we create a second layer except only 2 meters tall and only 3 sections of them at the front are 2 meters tall the 4th section will be 1 meter tall. >and the rightmost blue one is for the extra stuff submarines and ships need to be buoyant on the ocean.įirst of copy the original blocks and paste them above it and make it so that they are 3 meters tall except for the back most one at 2 meters tall. >the light blue one will be where all the decoration for the ship is. >the yellow green one will be where all of the ship movement parts will be. >the orange one will be where all of the ship armaments, range finders will be. >the blue one with a box is all of the parts used for ship hull making. So now we put the propeller there and mirror it as well. Pressing M on the keyboard will mirror it to the other side. Height, ForwardWidth, and BackwardWidth is all 0.5 metersĪnd this should be what it looks like when put on the ship.
Open the parts tab again then select adjustable hull block again. Remember that you can move selected parts by pressing T or fine tune the position with the setting tab.Īnd since we cant use the preset propeller shaft we can make one our-self. Now we can add the rudder and the propellers. Well set that to 1 and then use W,A,S,D to rotate that block around so that it becomes like this.Īfter that just swap the width of forward and backward around.Īnd do that on the lower one as well in which the outcome should be like this. then check the part settings and look for height offset which is set to 0 correct? Instead now at the back most block select it. Now we get to the rear since that this will be a simple build for now we can just stop with a slight flat rear.īut now we will do something different but still the same. remember to not add anything to the point of the ship. Rinse and repeat until you are finished on the front part of the ship. Then we do that for the same block one more time to add another layer except this time we make it 2 meters smaller in width than the one above and make it so that the bottom most block has the part setting of 1 on BottomRoundness.Īfter that we set the forward spread and backward spread of the 2 layers so that they line up with each other. Then after that we set it to 3 meters tall and make it 1 meter smaller in width than the block above, What i’m doing now is just dividing 120 into 10 parts.) (make sure to have a calculator ready since you still want it to be the same size of the brick. I will go with 10 since that’s at the middle point of somewhat curvy and at the same time not so much. (ship segments determine how curvy we can make a ship so the more you have the more curves you can make) Now that we have the general ship size and width we now start to segment the brick that we have now. (as well as making bottom roundness to 0)
We are gonna go put 120 meters for the hull lengthĪnd 15 meters for both forward and backward width Īnd once we do delete the block we now want to select the adjustable block and put the X Y and Z coordinates of the block with in the settings Tab all to 0Īfter that we figure out what kind of ship we want to make and for the sake of simplicity im gonna go with a destroyer. First of all we go to the parts tab and select adjustable hulls and then put it somewhere on the block.Īnd then we delete that block.